Replacing A Kitchen Sink

To replace your top mounted kitchen sink start by shutting off the water supply valves then turning on the faucet to drain any remaining water from the line.

Replacing a kitchen sink. The common problems you may run into are. Learning how to replace a kitchen sink is only the beginning you can use this same process to replace bathroom sinks as well. Disconnect the trap from the sinks drainpipe using pliers.

In this video i replace a kitchen sink from cast iron to stainless steel. Next put buckets under the water supply lines disconnect the lines with an adjustable wrench and remove the drainpipe with pliers. Slide a putty knife under the rim of the sink to break its bond with the countertop.

On this video i replace a double kitchen sink with a single basin. Steps for replacing a kitchen sink and faucet. Trace the outline and create a new cutout with a jigsaw.

Replacing drain pipes under the kitchen sink and check for leaks at the p trap and where the strainer drain meets the bottom of the sink and make sure there is no water leak at the rubber gasket. If the nut is very tight hold the strainer in place from above with the pliers while you loosen it. Its just a matter of being informed and prepared.

This could cause domestic strife especially if the job turns into a half day or longer project so make sure the valves work before going to the home center. Use an adjustable wrench to disconnect the water supply lines from the valves. Close the hot and cold water shutoff valves under the sink.

Replacing the kitchen sink is possible if your a doityourselfer. If youre worried about replacing a kitchen sink on your own our trusted professionals offer installation services. If you see screws holding your strainer in place remove.